Brass Y-connector - Barbed fittings - Diameter of your choice
Brass Y-connector - Barbed fittings - Diameter of your choice
Simplify the plumbing in your van with this brass Y-connector. Its three barbed fittings allow you to join or split a water circuit (pump, tank, water heater) smoothly, with no sharp bends or friction points. A robust and easy-to-fit solution, requiring no screwing or complex tools, to neatly organise your water network in a van or camper van.
BRASS Y-CONNECTOR: a smooth split for your water circuit
Joining two water pipes into one, or splitting a line without creating too sharp an angle: that is the purpose of this Y-connector. Unlike a T-connector which branches off perpendicularly, its Y configuration guides the flow at a more gradual angle, reducing turbulence and friction points in the hose.
Made from brass, this connector offers good durability against mechanical stress and temperature fluctuations that a plastic model handles less well. It is particularly recommended for sections of pipework subject to repeated vibrations, or located near a heat source such as a water heater outlet.
Its three barbed fittings accept flexible hose directly: insert each end then lock the connection with a hose clamp. The Y shape also makes it easier to route the hose in areas where bending space is limited — often a real challenge when fitting out a van.
This connector is suitable for both a clean water circuit and a grey water drainage system, to combine the supply from two water points or branch a line towards an ancillary piece of equipment (expansion vessel, filter). For a perpendicular branch rather than an angled one, a Ø10mm T-connector remains the most straightforward solution. Also browse our full range of connectors and fittings to complete your circuit.
How to install the brass Y-connector?
No drilling required: cut your flexible hose at the desired point, then push each section onto one of the three barbed fittings of the connector. Use a hose suitable for 10 mm diameter and secure each joint with a hose clamp for a watertight connection.
Technical specifications of the brass Y-connector
- Connector type: Y, 3-way
- Material: Brass
- Fitting type: Barbed (3 identical fittings, nipple-type)
- Diameter: 10 mm / 8 mm (choice) on all three outlets
- Fixing: By hose clamp (not included), no screwing required
- Compatibility: Flexible hoses with 10 mm internal diameter
- Use: Clean water or grey water circuits in vans and camper vans
- Packaging: Sold individually
-
Best selling