Kit d'isolation L2H2 Armaflex - Flocons - Liège

Kit d'isolation L2H2 Armaflex - Flocons - Liège

2.722_L2H2
€629.51 Inc. VAT

Retrouvez ce qui se fait de mieux pour l'isolation de véhicule aménagé camping-car dans ce kit mixte Armaflex / flocons d'Armaflex pour véhicule L2H2.
Se protéger des variations de température est un impératif pour tout voyageur nomade qui souhaite profiter confortablement de son fourgon aménagé.

Pack products My pack description
Expédié sous 24h

Man cleaning the walls of a van with Cleaner Armaflex and a cloth

Step 2: Insulate the walls and ceiling

Unroll the 19 mm Armaflex ChezMoi over the walls and ceiling, starting from the bottom and peeling off the protective film as you go.

Smooth each section by hand to expel the air, then reinforce the ceiling with mechanical fixings every 500 mm.

Step 1: Prepare the surfaces

Degrease the sheet metal with Cleaner Armaflex, from top to bottom, before any fitting. A perfectly clean and dry surface is essential: the slightest trace of grease or dust will prevent the adhesive from holding over time.

Fit your battens and mechanical fixings before the insulation, so as not to crush it once in place.

Fitting Armaflex ChezMoi 19 mm

Filling the reinforcements of a van with 10 mm Armaflex

Step 3: Treat reinforcements and wheel arches

The 10 mm Armaflex ChezMoi, thinner and more flexible, slides into the uprights, side rails and wheel arches that the 19 mm cannot conform to.

Cut it with a fresh blade and a 5 mm margin to compensate for irregularities in the sheet metal.

Step 4: Fill the doors with flakes

Fit the Proclima Intello vapour barrier using the adhesive tape, making sure to leave a large enough opening. Inject the Armaflex flakes, and close the vapour barrier as you fill. Tamp down lightly to avoid air pockets, but without compressing the material.

Once all the nooks and crannies of the door are filled, finish sealing the vapour barrier with the adhesive tape to block water vapour.

Step 5: Seal the joints

Every joint between two lengths of Armaflex ChezMoi, every corner and every cut must be sealed with Tape Armaflex ChezMoi. A single exposed point is enough to create a cold bridge where condensation settles, with a risk of corrosion on the sheet metal.

Be generous — now is not the time to hold back!

Cutting a cork roll with a cutter

Person unrolling a roll of Armaflex in strip form

Step 6: Cover the floor

Apply high-performance spray adhesive to the floor metal sheet, then roll out the 4 mm cork on top. Thin and flexible, it takes up almost no floor height while cutting out the cold rising from the ground.

Once fitted, your van is fully insulated — you can move on to the next stage of your build!

Pack contents

Complete coverage of your L2H2, with no cold spots left behind

Armaflex ChezMoi insulates your L2H2 van from floor to ceiling, including the walls and reinforcements.

Yet it is on the doors that this kit is particularly clever: Armaflex flakes, poured directly into the cavity, conform to every nook without leaving a cold spot, where a cut panel sometimes leaves gaps. Cork completes the assembly at floor level. Quantities already calibrated for this size, adhesives and accessories included.

Compatible with L2H2 vans on the market (Renault Master, Peugeot Boxer, Citroën Jumper, Fiat Ducato, Mercedes Sprinter, Ford Transit and equivalents), this kit covers walls, ceiling, doors, wheel arches and floor.

  • Quantities calibrated for an L2H2: no more guesswork or wasteful offcuts.
  • Complete coverage with no cold spots: the flakes conform to every nook of the doors, with no gaps.
  • Armaflex ChezMoi, designed for vans: unlike the former AF, which was designed for construction.
  • Easy installation with no prior experience: self-adhesive or loose-fill materials.
  • Zero complex cutting in difficult areas: the flakes are poured and lightly packed, with no millimetre-precise adjustments needed.

 

Contents of the L2H2 insulation kit

Walls, ceiling and structural reinforcements

 

Doors

 

Wheel arches

  • Armaflex ChezMoi 10 mm self-adhesive (quantity included above)

 

Floor

 

Materials chosen for their role in insulation

Armaflex ChezMoi — the insulator designed for vans

The successor to Armaflex AF, ChezMoi uses the same closed-cell technology in a formulation designed from the outset for van conversion rather than construction. Its integrated vapour barrier means there is no need to add a separate vapour check to the walls and ceiling.

  • Role in the kit: walls, ceiling, reinforcements, wheel arches
  • Thickness / packaging: 19 mm (6 m² roll) and 10 mm (10 m² roll)
  • Thermal conductivity (λ): 0.035 W/(m·K)
  • Integrated vapour barrier: closed cells, no vapour check to add
  • Antimicrobial treatment: Microban®, integrated into the material
  • Service temperature: -50 °C to +85 °C
  • VOC emissions: A+ rating (ISO 16 000)
  • Manufacturer's warranty: 10 years
  • Origin / manufacture: Europe, Armacell technology

 

Armaflex flakes — the loose-fill insulator for impossible nooks

Armaflex flakes offer the same insulating properties as roll Armaflex, in a form that pours and conforms to any cavity — a solution for doors and areas that cut panels would be far more complex to cover!

  • Role in the kit: doors
  • Packaging: 5 kg bag
  • Nature: same material as roll Armaflex, in granule form
  • Installation method: poured and lightly packed into the cavity

 

Cork — the natural floor insulator

Naturally rot-proof and moisture-resistant, cork insulates the floor without adding unnecessary thickness. Its lightness and flexibility make it easy to install with spray adhesive, directly onto the metal sheet.

  • Role in the kit: floor
  • Thickness / packaging: 4 mm (4 m² roll)
  • Moisture resistance: rot-proof, naturally water-resistant
  • Origin / manufacture: natural material

You might also be interested in

Delivery date

Carrier Information Delivery
DPD Predict 48/72h with scheduled delivery
Retrait au dépôt 24h after order (except made-to-order products) - 10 Chemin du Gué 42700 Firminy
* with direct payment methods (e.g. credit card)